Advanced Satellite Communication Lab Trainer
Our Advanced Satellite Communication Lab Trainer has built in antennas which work in the microwave range of 5.8GHz & 2.4GHz. The trainer provides a wide range of Baud rates / Microwave modulation rates in a PC to PC link. The Advanced Satellite Communication Lab Trainer is also used for the study of the following parameters:
- Receiver and Satellite Emulator.
- Variable path loss at uplink and downlink channels.
- Measurement and Analysis of Carrier to Noise Ratio and Signal to Noise Ratio to examine the quality of signal.
- High RF output power and low noise.
- Built in Interference Generator and Noise Figure Analyser.
- Condenser microphone and speaker are provided for audio link.
- Display of PLL synthesized frequency in Transmitter.
- Camera and Video monitor for video link.
- Transponder for up-link and down-link.
- Dish X 2 & Patch X 2 for linear & circular polarization study for Helix antennas for 2.4 & 5.8GHz.
- Signal monitoring outputs at uplink & downlink.
Advanced Satellite Communication Lab Trainer
Advanced Satellite Communication Lab Trainer
A satellite is basically a long distance communication system which can work on point to point as well as point to multi point communication system. A communication satellite is a RF (radio frequency) transmitter and receiver which are collectively known as transponder.
Antennas of the satellite are its main components because it receives and re transmits the same signal. The basic need for communication satellite arose to overcome line of sight transmission problem, where lot of disturbances occur due to activities on earth and also it is a small distance mode because of the limitation due to earth’s crust which is round.
